Understand the problems that should be paid attention to during the installation process of the tape tension testing machine

Understand the problems that should be paid attention to during the installation process of the tape tension testing machine

Dongguan Haida Instrument 400-071-1808/0769-89280808

The tape tension tester is also an electronic tension tester. The electronic tension tester is installed in a clean and dry and even temperature house. The possibility of a long beam bending test on the machine and the use of a mirror extender should be taken into consideration. The possibility of testing, so there should be enough free space around the test machine.

The electronic tension test body and dynamometer do not need special foundation for installation. Only base the foundation diagram on the general foundation and leave the anchor bolt hole to solidify.

To find the main body of the tester, you can set the level meter on the outer circle of the cylinder to find a good level by two positions in the vertical and horizontal directions of the base, and find a ± 1 grid with a level meter with an accuracy of 0.10/100 mm. Horn to adjust.

The dynamometer has two holes at the top to allow it to be worn when reinstalled.

The level of the dynamometer is very important. When the level is found, align the left side of the oscillating rod with the reticle of the standard line plate so that it will not move, and then use the bending rule to rest on the large surface of the upper part of the oscillating rod to 0.1/1000 mm. Level gauge on the ruler to find ± 2 cells. The horn is not placed underneath the base, and both the pendulum and the pendulum must be aligned to zero.

The electronic tensile testing machine will open the iron door behind the dynamometer and check whether the line of the small hammer is wound in the groove of the pinion coaxial pinion. The length of the tie line should be appropriate, not too long or too short, the limit is The longest can not touch the evacuation remembered on the diaphragm, the shortest period of time for the pinion to rotate does not touch the pinion.

The details of the electronic tensile testing machine are mainly focused on the connection of various parts and components, and the techniques for the installation of electronic tensile testing machines are carefully understood.