Although there is no problem in the working temperature of the constant temperature and humidity chamber, the noise is relatively large as the "age" increases. However, it is a pity to eliminate it because of the noise. In fact, noise pollution is not difficult to solve. As long as you master the following methods, you can effectively reduce the noise.
(1) Pipeline and box reinforcement
Check to see if the connection between the outer pipe and the casing is loose, so as to avoid resonance when the compressor is working. In order to avoid loosening, the outer pipe must be fixed, and the bolt should be spring washer.
(2) Suppressing tube vibration with rubber block
The constant temperature and humidity chamber is more noisy during use. The bicycle tire can be taken out, cut into a round shape with a diameter of 30 mm, and a circular hole with a diameter of about 5 mm is cut out in the middle, and then cut from the outside to the center to make the rubber Paste on the tube. When the compressor of the high-low temperature alternating heat and humidity tank is running, touch the pipe by hand. If there is a tube with a feeling of shaking, you can put a few rubber blocks on it. One test box needs to be 10~20, and the noise will drop immediately. Come down. This is because the rubber block suppresses the "resonance" caused by the vibration of the tube.
(3) The back of the constant temperature and humidity chamber has a certain inclination angle to the wall surface
The back surface of the high and low temperature alternating heat and humidity chamber is inclined at a certain angle to the wall surface, and after the back surface and the wall surface are inclined at 1-3 degrees, the test box has a large opening on one side and a small opening on one side, and has a trumpet shape. The large side emits a lot of noise and should face the object; the small side has less noise and should face the active area of ​​the person.
(4) Appropriately heighten the four corners of the constant temperature and humidity chamber
The constant temperature and humidity chamber is 3~6 cm high and the balance of the four corners is adjusted to increase the air convection space at the bottom of the box. In this way, compressor noise and other noise from the bottom of the cabinet are removed from the bottom of the cabinet, reducing noise from the sides and upper portions of the cabinet.
(5) The compressor base should be firm
If the compressor is pressed tightly by hand, the noise is significantly reduced, and the noise is increased by hand. This is generally caused by uneven force on the fixed damping pad of the compressor base or loose bolts and unstable compressor bottom plate. The connecting part bolts should be adjusted and tightened and the loss of the elastic washer should be replaced.
Modern and stylish Art Deco tables made from clear glass from our Venetian mirrored furniture collection are ideal for adding a touch of beauty to your home. Featuring a unique and stunning frame design, this piece is sure to impress and become an instant favorite
Console Table, mirrored console table, hallway table, entryway table, glass console table
Hongsing Glass Hardware Porduct Co Ltd , https://www.hongsingglass.com